Supermicro SUPERSERVER 8048B-C0R3FT, User Manual

Page: 12 / 156

1-2
SUPERSERVER 8048B-TR3F/C0R3FT User's Manual
Note:
For your system to work properly, please follow the links below to download
all necessary drivers/utilities and the user’s manual for your server.
•
Supermicro product manuals: http://www.supermicro.com/support/manuals/
•
Product drivers and utilities: ftp://ftp.supermicro.com
•
Product safety information:
http://www.supermicro.com/about/policies/safety_information.cfm
•
If you have any questions, please contact our support team at:
support@supermicro.com
1-2 Serverboard Features
At the heart of the SuperServer 8048B-TR3F/C0R3FT lies the X10QBL-(CT), a
quad processor serverboard based on the Intel C602J chipset. Below are the main
features of the X10QBL-(CT). (See Figure 1-1 for a block diagram of the chipset).
Processors
The X10QBL-(CT) supports four E7-4800/8800 v3 Series processors in Socket R1
type sockets. Each processor supports three full-width Intel QuickPath Interconnect
(QPI) links (Data Transfer Rate of up to 9.6 GT/s per direction) Please refer to our
web site for a complete listing of supported processors (
www.supermicro.com ).
Memory
The X10QBL-(CT) has thirty-two (32) single/dual/tri/quad channel 240-
pin DIMM sockets that can support up to 1 TB of Registered (RDIMM) or
2 TB Load Reduced (LRDIMM) ECC DDR3 1600/1333/1066 MHz speed
S D R A M i n a t w o - c h a n n e l m e m o r y b u s . M e m o r y s i z e s o f
4GB, 8GB, 16GB, 32GB and 64GB size @ 1.35V/1.5V voltages are supported.
Please refer to Chapter 5 for installing memory.
Serial ATA
An on-chip (Intel C602J) SATA controller is integrated into the X10QBL-(CT) to
provide a six-port SATA subsystem (two SATA 3.0 and four SATA 2.0 ports), which
are all RAID 0, 1, 5 and 10 Windows/LINUX supported. The SATA drives are
hot-swappable units.
Note:
You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.