Supermicro SUPERSERVER 6027R-CDNRT+, User Manual

Page: 70 / 128

5-22
S
UPER
S
ERVER 6027R-CDNRT+ User's Manual
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the onboard Ether-
net (RJ45) ports LAN1 and LAN2. See
the table on the right for jumper set-
tings. The default setting is enabled.
Watch Dog Enable/Disable
JWD1 controls the Watch Dog func-
tion. Watch Dog is a system monitor
that can reboot the system when a
software application “hangs”. Pins 1-2
will cause WD to reset the system if an
application hangs. Pins 2-3 will gener-
ate a non-maskable interrupt signal for
the application that has hung. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
BIOS.
Note:
When enabled, the user needs
to write their own application software
to disable the Watch Dog Timer.
LAN Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
BMC Enable/Disable
Jumper JPB1 allows you to enable the
embedded BMC (Baseboard Manage-
ment) Controller to provide IPMI 2.0/
KVM support on the serverboard.
See the table on the right for jumper
settings.
BMC Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC Enabled
Pins 2-3 Normal
Onboard Buzzer Enable/Disable
Close jumper JSPK1 to use the
onboard buzzer. The default setting
is closed for normal system mode.
See the table on the right for jumper
settings.
Onboard Buzzer
Jumper Settings
Jumper Setting Definition
Closed Enabled
Open Disabled