Supermicro SUPERSERVER 6014A-8, User Manual

Page: 22 / 130

2-4
S
UPER
S
ERVER 6014A-8 Manual
2-4 Installing the System into a Rack
This section provides information on installing the SuperServer 6014A-8 into
a rack unit with the rack rails provided. If the 6014A-8 has already been
mounted into a rack, you can skip ahead to Sections 2-5 and 2-6. There are
a variety of rack units on the market, which may mean the assembly proce-
dure will differ slightly. You should also refer to the installation instructions
that came with the rack unit you are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the SuperServer 6014A-
8. Each of these assemblies consists of two sections: an inner fixed chassis
rail that secures to the 6014A-8 (A) and an outer fixed rack rail that secures
directly to the rack itself (B). Two pairs of short brackets to be used on the front
side of the outer rails are also included.
Installing the Inner Rails
First, locate the right inner rail (the rail that will be used on the right side of the
chassis when you face the front of the chassis). Align the four square holes on
the right inner rail against the hooks on the right side of the chassis. Securely
attach the rail to the chassis with two M4 flat head screws. Repeat these steps
to install the left inner rail to the left side of the chassis.
Figure 2-1. SC813S-500 with Rack Rails Attached
(with optional front bezel shown)