Supermicro SUPERSERVER 6012P-8, User Manual

Page: 42 / 104

5-8
S
UPERSERVER 6012P-8 User’s Manual
Figure 5-5b. Top View of DIMM Slot
Figure 5-5a. Side View of DIMM Installation into Slot
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward
to free the DIMM from the slot.
4. When installing modules into the two Bank 2 slots, you will need to
remove the power supply due to space constraints. Memory slots are
positioned at a 25 degree angle to fit full-sized memory modules into a
1U chassis.
Memory Support
The P4DPR-8G2 only supports ECC registered PC1600 (DDR-200) memory.
PC2100 (DDR-266) is supported but only at 200 MHz (PC1600 speed).
PC100/133 SDRAM is not supported. You should not mix DIMMs of different
sizes and speeds.
See Figures 5-5a and 5-5b for installing and removing memory modules.