52
SuperServer 5039MS-H8TRF User's Manual
VGA Enable/Disable
Close pins 2 and 3 of jumper JPG1 to disable the onboard VGA port using the onboard
graphics controller. The default setting is Enabled.
VGA Enable/Disable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
Manufacturer Mode Select
Close pin 2 and pin 3 of jumper JPME2 to bypass SPI flash security and force the system
to operate in the manufacturer mode, which will allow the user to flash the system firmware
from a host server for system setting modifications. The default setting is Normal.
Manufacturer Mode
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Normal (Default)
Pins 2-3
Manufacturer Mode
SMBus to PCI Slots
Jumpers JI
2
C1 and JI
2
C2 allow you to connect the System Management Bus (I
2
C) to the
PCI-E/PCI slots. The default setting is Open (Disabled.)
Both jumpers must be set to the
same setting (JI
2
C1 controls the clock and JI
2
C2 controls the data).
SMBus to PCI Slots
Jumper Settings
JI
2
C1 Setting
JI
2
C2 Setting
Definition
JI
2
C1: Closed JI
2
C2:Closed
Enabled
JI
2
C1: Open
JI
2
C2: Open
Disabled
BIOS Recovery
The BIOS Recovery Switch at JBR1 is used to enable or disable the BIOS Recovery feature
of the motherboard. Slide the switch from the default position to begin the recovery process. .
BIOS Recovery
Jumper Settings
Jumper Setting
Definition
Off
Normal (Default)
On
Recover
