Supermicro SUPERSERVER 5018D-FN8T, User Manual

Page: 47 / 124

Chapter 5: Advanced Motherboard Setup
5-5
2. Install the DIMM module straight down into the socket until it is securely
seated in the socket. The side clips will automatically lock the module into
place.
Memory Installation Guidelines
When installing memory modules, the DIMM slots should be populated in the
following order: DIMMA1, DIMMB1, then DIMMA2, DIMMB2.
•
Always use DDR4 DIMM modules of the same size, type and speed. Mixing
memory modules of different types and speeds is not allowed.
•
The motherboard will support one DIMM module installed. However, for best
memory performance, install DIMM modules in pairs.
Installing DIMM Memory Modules
1. Align the key on the bottom of the DIMM module against the key on the
memory slot. Take note of the notches on the side of the DIMM module, and
of the locking clips on the socket to avoid causing damage.
Module Notch
Module Key
Socket Key
Locking Clip
5-5 Expansion Cards
M.2 is formerly known as Next Generation Form Factor (NGFF). The JMD1 M.2
connector is designed for internal mounting devices. The X10SDV-TP8F deploys
an M key only (2242/2280/22110) dedicated for SSD devices with the ultimate
performance capability in a PCI Express 3.0 X4 interface for native PCIe SSD
support. The M.2 is mux with the I-SATA4 port for legacy SATA SSD devices.