14
SuperServer 1029UX-LL1-S16/LL2-S16/LL3-S16 User's Manual
Quick Reference Table
Jumper
Description
Default Setting
JBR1
BIOS Recovery
Pins 1-2 (Normal)
JBT1
CMOS Clear
Open (Normal)
JPG1
VGA Enable/Disable
Pins 1-2 (Enabled)
JPME1
Recovery Mode
Pins 1-2 (Normal)
JPME2
Manufacturing Mode
Pins 1-2 (Normal)
JVRM1
VRM Programming
Pins 1-2 (Default)
JWD1
Watch Dog
Pins 1-2 (Reset)
LED
Description
Status
LE2
Standby PWR LED
Green: SB Power On
LED1
UID LED
Solid Blue: Unit Identified
LEDM1
BMC Heartbeat LED
Blinking Green: BMC Normal
Connector
Description
BIOS
BIOS
BT1
Onboard Battery
COM1
COM Port
FAN1 ~ FAN8
System/CPU Fan Headers (FAN1: CPU Fan)
IPMI_LAN JLAN1
Dedicated IPMI LAN Port
I-SATA0 ~ I-SATA7
Intel® PCH SATA 3.0 Ports
JF1
Front Control Panel Header
JGPW1 - JGPW4
(GPU PWR1 - GPU PWR4) GPU and VGA Device Power Connectors
JHFI1, JHFI2
HFI connector headers for CPU1 and CPU2 respectively (see Notes below)
JHSSI1 - JHSSI2
Connector for FPGA GPIO signal
JIPMB1
System Management Bus Header for IPMI2.0
JL1
Chassis Intrusion Header
JNVI
2
C1, JNVI
2
C2
VPP_CPU1, VPP-CPU2 - System Management Bus
JP2
CPLD programming
JPW1 - JPW4
(BP PWR1 - BP PWR4) Backplane power connectors for hard drives
JRK1
Intel Raid Key Header
Notes:
For the HFI sideband carrier card to function properly, install the HFI card to an
appropriate PCI-E slot of your choice, and install an F model processor in CPU Socket#1.
Connect an HFI cable from the HFI card to JHFI header and connect an IFP cable from HFI
card to the processor. (See Chapter 3 for more details.)
