SuperServer 1029U-TN10RT User's Manual
96
sSATA Device Type (sSATA Port 0~ Port 5)
Use this item to specify if the SATA port specified by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are
Hard Disk Drive
and Solid State Drive.
PCIe/PCI/PnP Configuration
The following information will be displayed:
•
PCI Bus Driver Version
PCI Devices Common Settings:
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Disabled and
Enabled
.
SR-IOV Support
Use this feature to enable or disable Single Root IO Virtualization support. The options are
Disabled
and Enabled.
MMIO High Base
Use this item to select the base memory size according to memory-address mapping for the
IO hub. The options are
56T
, 40T, 24T, 16T, 4T, and 1T.
MMIO High Granularity Size
Use this item to select the high memory size according to memory-address mapping for the
IO hub. The options are 1G, 4G, 16G, 64G,
256G
, and 1024G.
PCI PERR/SERR Support
Select Enabled to activate PCI Error and System Error report handling. The options are
Disabled and
Enabled
.
Maximum Read Request
Select Auto to allow the system BIOS to automatically set the maximum read request size
for a PCI-E device to enhance system performance. The options are
Auto
, 128 Bytes, 256
Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes, and 4096 Bytes.
MMCFG Base
Use this feature to select the default value for the PCI MMIO (Memory-Mapped IO) base
address. The options are 1G, 1.5G, 1.75G,
2G
, 2.25G, and 3G.
NVMe Firmware Source
Use this item to select the NVMe firmware to support booting. The options are
Vendor
Defined Firmware
and AMI Native Support. The default option,
Vendor Defined Firmware
,
is pre-installed on the drive and may resolve errata or enable innovative functions for the
drive. The other option, AMI Native Support, is offered by the BIOS with a generic method.
