Supermicro SUPERSERVER 1025C-UR, User Manual, Page: 65 / 108

Chapter 6: Advanced Chassis Setup
6-5
Align the drive in the carrier so that the screw holes of both line up. Note that
there are holes in the carrier marked “SATA” to aid in correct installation.
Secure the drive to the carrier with four screws as illustrated below.
Insert the drive carrier into its bay, keeping the carrier oriented so that the
hard drive is on the top of the carrier and the release button is on the right
side. When the carrier reaches the rear of the bay, the release handle will
retract.
Push the handle in until it clicks into its locked position
Removing a Hard Drive (Figure 6-4)
To remove a carrier, push the release button located beside the drive LEDs.
Swing the handle fully out and use it to pull the unit straight out (see Figure
6-4).
Note: Your operating system must have RAID support to enable the hot-plug ca-
pability of the hard drives.
2.
3.
4.
5.
1.
2.
Warning: Except for short periods of time (such as for swapping
hard drives), do not operate the server with the hard drive carriers
empty.
!
Figure 6-3: Installing a Hard Drive into a Carrier