Supermicro Supero SuperServer 5018A-MLTN4, User Manual

Page: 90 / 120

7-6
SUPERSERVER 5018A-MLTN4 User's Manual
SATA Mode
This item selects the mode for the installed SATA drives. The options are IDE and
AHCI .
IDE Mode (Available when the item above: SATA Mode is set to IDE)
Select Legacy for the SATA port specifi ed by the user to support a Legacy SATA
device. The options are Legacy and Native.
SATA 3 Speed
Use this item to set the highest speed allowed for SATA interface connections for
SATA 3 controller. The options are Gen 1, Gen 2, and Gen 3 .
LPM (Line Power Management)
Select Enabled to enable Line Power Management support. The options are En-
abled and Disabled .
SATA Port0/Port1
This item displays the information detected on the device installed on the par-
ticular SATA port.
•
Model Name
SATA Port0/Port1
Select Enabled to enable a SATA port selected by the user. The options are
Enabled and Disabled.
Spin Up
On an edge detect from 0 to 1, set this item to allow the PCH to start a COM-
RESET initialization sequence to the device installed on a SATA port specifi ed
by the user. The options are Enabled and Disabled .
External Device
Select Enabled for the SATA port specifi ed by the user to support an external
device. The options are Enabled and Disabled .
Hot Plug
Select Enabled to enable hot-plugging support on a SATA drive specifi ed by the
user, which will allow the user to replace the SATA disk drive without shutting
down the system. The options are Enabled and Disabled.