Supermicro Supero SC847DE16-R2K02JBOD, User Manual

Page: 97 / 103

F-12
SC847DJ Chassis Manual
JP1
JP2
JP3
F-11 SC417B
Cabling
SAS3 I
2
C Cabling in the SC417B Chassis
Use the diagram below to connect the I
2
C cabling. Ensure that the JP5 jumper on
the CSE-PTJBOD-CB3 is cabled correctly according to the table below.
CSE-PTJBOD-CB3
BPN-SAS3-216EL1/EL2
Connected to the Primary
I
2
C Connector (SMB)
BPN-SAS3-216EL1/EL2
Connected to the Primary
I
2
C Connector (SMB)
BPN-SAS3-216EL1/EL2
Connected to the Primary
I
2
C Connector (SMB)
Figure F-8. SAS3 I
2
C Cabling in the SC417B Chassis
Jumper Settings
Jumper Setting
JP5
Pins 1-2: SAS3 setting (Default)
Pins 2-3: SAS2 and SC847D setting
CBL-CDAT-0601
CBL-CDAT-0601
CBL-CDAT-0601
When enabling SAS2/SAS3 functionality, use the connectors on the upper left of
the CSE-PTJBOD-CB3 power board (See Page 2-4) and set the JP5 jumper as
shown in the chart above.
When an SC847D chassis is being used, use the connectors along the bottom
edge fo the power board (See Page 2-4) and set the JP5 jumper as shown in the
chart above.