Supermicro SSE-X3648S, Installation Manual

Page: 8 / 46

SSE-X3648S/SSE-X3648SR Switch Installation Manual
1-2
Back Panel
The SSE-X3648S/SSE-X3648SR switches provides an RJ-45 serial console port in the
rear of the switch. Users perform the local and telnet configuration through this port.
The back panel of the SSE-X3648S/SSE-X3648SR switch also includes two redundant
hot-swappable AC power supply modules, four fans and one rear panel card.
The console port supports asynchronous mode. To set this up just set the data bit as 8,
the stop bit as 1, the parity bit as none, and the default baud rate as 115,200bps.
Cautions:
1. The USB port on the rear panel card only supports data transmission. It does not
support power supply over USB.
2. The rear panel card does not support hot plug.
3. Replacement of the rear panel card must be done by a professional.
1-3 Status LEDs
There are indicator LEDs on the front panel of the SSE-X3648S/SSE-X3648SR
switches. There are 48 SFP+ Port Indicator LEDs, 24 QSFP+ Port Indicator LEDs, two
Power Supply Indicator LEDs, and a System Automatic Diagnosis LED. These LEDs
are described below in
Table 1-3 , Table 1-4 and Table 1-5 .
Figure 1-1. Front Panel of the SSE-X3648S/SSE-X3648SR Switches
Table 1-2. Rear Panel Descriptions of the SSE-X3648S/SSE-X3648SR Switch
Type
10/100/1000Base-T
Ethernet Port
Console Port
USB2.0
Interface
SSE-X3648S 1 1 1
Figure 1-2. Back Panel of the SSE-X3648S/SSE-X3648SR Switch
SFP+ Ports QSFP+ Ports
Power
Supply
Console Ports
Fans
Power
Supply
Fans
USB Port