Chapter 30: Congestion Control Commands
Automatic Traffic Control Commands
– 994 –
broadcast
- Specifies automatic storm control for broadcast traffic.
multicast
- Specifies automatic storm control for multicast traffic.
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
•
This command can be used to automatically stop a control response of
rate-limiting after the specified action has been triggered and the
release timer has expired.
•
To release a control response which has shut down a port after the
specified action has been triggered and the release timer has expired,
auto-traffic-control control-release
command.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast auto-control-release
Console(config-if)#
auto-traffic-control
control-release
This command manually releases a control response.
S
YNTAX
auto-traffic-control
{
broadcast
|
multicast
}
control-release
broadcast
- Specifies automatic storm control for broadcast traffic.
multicast
- Specifies automatic storm control for multicast traffic.
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
This command can be used to manually stop a control response of rate-
limiting or port shutdown any time after the specified action has been
triggered.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast control-release
Console(config-if)#
Summary of Contents for SSE-G2252
