9
Chapter 1: Introduction
1.4 Chassis Features
Control Panel
Power switches and status LEDs are located on the control panel on the front of the chassis.
Control Panel Features
Item
Feature
Description
1
Power Button
The main power button is used to apply or remove power from the power supply
to the server. Turning off system power with this button removes the main power
but maintains standby power.
2
Reset Button
The reset button is used to reboot the system.
3
Power LED
Indicates power is being supplied to the system power supply. This LED should
normally be illuminated when the system is operating.
4
HDD LED
Indicates hard drive activity when flashing.
5
NIC1 LED
Indicates network activity on LAN port 1 when flashing.
6
NIC2 LED
Indicates network activity on LAN port 2 when flashing.
7
Information LED
See table below for details.
8
Power Fail LED
This LED flashes to indicate one of the redundant power supply modules has
failed. The flashing light should be accompanied by an audible warning.
9
USB0 Port
USB 3.0 port
10
USB1 Port
USB 3.0 port
Figure 1-1. Control Panel View
Information LED
Status
Description
Continuously on and red
An overheat condition has occurred.
(This may be caused by cable congestion.)
Blinking red (1Hz)
Fan failure, check for an inoperative fan.
Solid blue
Local UID has been activated. Use this function to
locate the server in a rackmount environment.
Blinking blue
Remote UID is on. Use this function to identify the
server from a remote location.
1
8
9
7
6
5
4
3
2
10
