Supermicro SC113M Series, User Manual, Page: 39 / 83

SC113M Chassis Manual
4-4
Figure 4-3. Removing the Dummy Drive From the Carrier
Installing a Hard Drive into a Carrier
1. Remove the four screws securing the dummy drive to the hard drive carrier
and set them aside for later use.
2. Lift the dummy drive up and out of the carrier.
3. Insert a drive into the carrier with the printed circuit board side facing down-
ward, with the connector oriented at the rear of the carrier.
4. Align the drive in the carrier so that the mounting holes in the drive align
with the mounting holes in the carrier. Note that there are holes in the carrier
marked “SATA” to aid in correct installation of the drive.
5. Secure the drive to the carrier with four screws previously set aside.
6. Insert the drive carrier into the chassis drive bay, keeping the carrier oriented
so that the hard drive is on the top of the carrier and the release button is on
the right side. When the carrier reaches the back of the drive bay, the release
handle will retract.
7. Push the handle in until the drive carrier clicks into the locked position.