Supermicro SBI-7425C-S3E, User Manual

Page: 25 / 86

3-7
Chapter 3: Setup and Installation
Figure 3-5. 6-slot DIMM Numbering
DIMM Installation
Installing DIMM Memory Modules
1. Power down the blade module (see "Powering Down a Blade Unit" on page 3-1 ).
2. Remove the blade from the enclosure and the cover from the blade (see
"Removing/Replacing the Blade Cover" on page 3-2 ).
3. Remove the air shroud that covers the DIMM slots.
NOTE:
The DIMM slot number specified in Table 3-1 equals the DIMM slot to
be populated. The “---” notation indicates that the DIMM slot should be left
unpopulated.
NOTE:
Though multiple DIMM memory module types and speeds may be
supported, you need to use DIMM memory modules of the same speed and
type.
WARNING:
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage.
Center of Board Edge of Board
Toward CPU’s
DI
MM3B
DI
MM2A
DI
MM3A
DI
MM1B
DI
MM2B
DI
MM1A