Supermicro SBI-7126T-T1E, User Manual

Page: 14 / 76

SBI-7126T-T1L/T1E Blade Module User’s Manual
1-2
1-3 Blade Module Features
Table 1-1 lists the main features of the SBI-7126T-T1L/T1E blade module. See the
proceeding section for components typically included in a blade system and other
optional components. Specific details on the SBI-7126T-T1L/T1E blade module is found
in
Chapter 4: "Blade Module Features" on page 4-1 .
Processors
The SBI-7126T-T1L/T1E blade module supports up to dual 1366-pin Intel Xeon 5500
series processors.
Refer to the Supermicro web site for a complete listing of supported processors ( http://
www.supermicro.com/products/superblade ). Please note that you will need to check the
detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the SBI-7126T-T1L/T1E blade module are
found in
Chapter 3: "Setup and Installation" on page 3-1 .
Memory
The SBI-7126T-T1L/T1E blade module has six 240-pin DIMM sockets that can support
up to 12 GB of ECC Unbuffered DDR3-1333/1066/800 SDRAM or 48 GB of ECC
Registered DDR3-1333/1066/800 SDRAM DIMMs. Both interleaved and
non-interleaved memory are supported, so you may populate any number of DIMM
slots.
Please refer to the Supermicro web site for a list of supported memory
(
www.supermicro.com/products/superblade ). The detailed specifications for a blade
module will contain a link to a list of recommended memory sizes and manufacturers.
Table 1-1. SBI-7126T-T1L/T1E Blade Specification Features
Mainboard
B8DTL-L (proprietary form factor)
Chassis Dimensions (HxWxD): 11.32” x 1.67” x 18.9”
Processors
Supports Dual 1366-pin LGA Socket processors for up to two Intel
®
64-bit
quad-core Xeon
®
series processors. Please refer to our web site for a
complete listing of supported processors.
FSB Speed QPI speed | Up to 6.4 GT/s
Chipset Intel 5500 Tylersburg/IOH-24D + ICH10R
Graphics Controller Onboard Matrox G200eW Graphics chip with 16MB of SDRAM
BIOS 32 Mb AMI
®
SPI Flash EPROM BIOS
Memory Capacity
Six 240-pin DIMM sockets supporting up to 48 GB of ECC Registered
DDR3-1333/1066/800 SDRAM DIMMs or 12 GB of ECC Unbuffered
DDR3-1333/1066/800 SDRAM DIMMs in two 3-DIMM slot banks.
SATA Controller ICH10R on-chip controller for two Serial ATA drives
Hard Drive Bays Two (2) hot-swap drive bays for 3.5" SATA disk drives