Supermicro SBA-7222G-T2, User Manual

Page: 54 / 74

SBA-7222G-T2 Blade Module User’s Manual
6-8
Super IO Device Configuration
The menu options in the S
UPER
IO C
ONFIGURATION
submenu and their descriptions are
shown in Table 6-6 .
Remote Access Configuration
The menu options in the R
EMOTE
A
CCESS
C
ONFIGURATION
submenu and their
descriptions are shown in Table 6-7 .
Table 6-6. Super IO Configuration Submenu
Menu Option Description
Serial Port1 Address
This option specifies the base I/O port address and Interrupt Request address of
serial port 1. The options are D
ISABLED
, 3F8/IRQ4 , 3E8/IRQ4 and 2E8/IRQ3.
• Select D
ISABLED
to prevent the serial port from accessing any system
resources. When this option is set to D
ISABLED
, the serial port physically
becomes unavailable.
• Select 3F8/IRQ4 to allow the serial port to use 3F8 as its I/O port address
and IRQ 4 for the interrupt address.
Serial Port2 Address
This option specifies the base I/O port address and Interrupt Request address of
serial port 2. The options are D
ISABLED
, 2F8/IRQ3 , 3E8/IRQ4 and 2E8/IRQ3.
Select D
ISABLED
to prevent the serial port from accessing any system resources.
When this option is set to D
ISABLED
, the serial port physically becomes
unavailable.
Select 2F8/IRQ3 to allow the serial port to use 2F8 as its I/O port address and
IRQ 3 for the interrupt address.
Serial Port 2 Attribute
This option can set COM 2 as a normal serial port or virtual COM for SOL.
Options are COM or
SOL .
Table 6-7. Remote Access Configuration Submenu
Menu Option Description
Remote Access
Allows you to Enable or Disable remote access. If enabled, the settings below
will appear.
Serial Port Number
Selects the serial port to use for console redirection. Options are COM1 and
COM2*
Serial Port Mode
Selects the serial port settings to use. Options are (115200 8, n, 1) , (57600 8,
N
,
1), (38400 8,
N
, 1), (19200 8,
N
, 1)
AND
(09600 8,
N
, 1).
Flow Control
Selects the flow control to be used for console redirection. Options are None,
H
ARDWARE
and S
OFTWARE
.
Redirection After
BIOS POST
Options are D
ISABLE
(no redirection after BIOS POST), B
OOT
L
OADER
(redirection during POST and during boot loader) and Always (redirection
always active). Note that some OS's may not work with this set to Always.
Terminal Type Selects the type of the target terminal: ANSI , VT100 and VT-UTF8.