Supermicro MicroBlade MBI-6119M-C2, User Manual

Page: 65 / 87

MBI-6119M-C2 MicroBlade Modules User’s Manual
5-14
Terminal Type
This feature allows the user to select the target terminal emulation type for
Console Redirection. Select VT100 to use the ASCII character set. Select
VT100+ to add color and function key support. Select ANSI to use the
extended ASCII character set. Select VT-UTF8 to use UTF8 encoding to
map Unicode characters into one or more bytes. The options are ANSI,
VT100, VT100+, and
VT-UTF8 .
Bits Per Second
This item sets the transmission speed for a serial port used in Console
Redirection. Make sure that the same speed is used in the host computer
and the client computer. A lower transmission speed may be required for
long and busy lines. The options are 9600, 19200, 57600, and
115200 (bits
per second).
Flow Control
This feature allows the user to set the flow control for Console Redirection
to prevent data loss caused by buffer overflow. Send a "Stop" signal to stop
sending data when the receiving buffer is full. Send a "Start" signal to start
sending data when the receiving buffer is empty. The options are
None,
Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits, Parity, Stop
Bits
The status of each item above is static displayed.
Table 5-8. SATA and RSTe Configuration Sub-menu
Menu Option Description
SATA Controller
This feature allows you to enable or disable the SATA controller. The
options are
Enabled and Disabled.
SATA Mode Selection Use this setting to configure the SATA for either the RAID or AHCI options.
SATA Port 0 ~ SATA Port 7 Use these settings to Enable or Disable SATA ports.
SATA0 ~ SATA7 Port Hot
Plug
This feature designates this port for hot plugging. Set this item to Enabled
for hot-plugging support, which will allow the user to replace a SATA drive
without shutting down the system. The options are
Enabled and Disabled.
SATA0 ~ SATA7 Port Spin
Up Device
If enabled for any of the ports Staggered Spin Up will be performed and
only the drives which have this option enabled will spin up at boot.
Otherwise (if disabled) all drives will spin up at boot. The options for this
setting are Enabled and
Disabled .
SATA0 ~ SATA7 Port SATA
Device Type This setting allows you to specify the selected port SATA device as being
either a
Hard Disk Drive or Solid State Drive.
Table 5-9. PCH-FW Configuration Sub-menu
Menu Option Description
PCH-FW Configuration
Information Static information for PCH-FW Configuration is shown for this sub-menu
when selected.
Table 5-7. Serial Port Console Redirection Sub-menu (Continued)
Menu Option Description