AOC-PG-i2+ Add-on Card User’s Manual
4-8
If Speed = 10 or 100, then both Speed and Duplex should be set. Auto-negotiation is
disabled, and the AutoNeg parameter is ignored. Partner SHOULD also be forced.
The
AutoNeg
parameter is used when more control is required over the auto-negotiation
process. It should be used when you wish to control which speed and duplex
combinations are advertised during the auto-negotiation process. The parameter may
be specified as either a decimal or hexadecimal value as determined by
Table 4-2
below.
Some examples of using
AutoNeg
:
modprobe e1000 AutoNeg=0x01 (Restricts autonegotiation to 10 Half)
modprobe e1000 AutoNeg=1 (Same as above)
modprobe e1000 AutoNeg=0x02 (Restricts autonegotiation to 10 Full)
modprobe e1000 AutoNeg=0x03 (Restricts autonegotiation to 10 Half or 10 Full)
modprobe e1000 AutoNeg=0x04 (Restricts autonegotiation to 100 Half)
modprobe e1000 AutoNeg=0x05 (Restricts autonegotiation to 10 Half or 100 Half)
modprobe e1000 AutoNeg=0x020 (Restricts autonegotiation to 1000 Full)
modprobe e1000 AutoNeg=32 (Same as above)
Note that when this parameter is used,
Speed
and
Duplex
must not be specified.
If the link partner is forced to a specific speed and duplex, then this parameter should
not be used. Instead, use the
Speed
and
Duplex
parameters previously mentioned to
force the adapter to the same speed and duplex.
Table 4-2. AutoNeg Parameter Values
Bit Position
Decimal Value
Hex Value
Speed (Mbps)
Duplex
7
128
80
N/A
–
6
64
40
N/A
–
5
32
20
1000
Full
4
16
10
N/A
–
3
8
8
100
Full
2
4
4
100
Half
1
2
1
10
Full
0
1
1
10
Half
Summary of Contents for AOC-PG-i2+
