Chapter 5: Advanced Serverboard Setup
5-9
5-8
S
UPER
S
TORAGE
S
YSTEM 6047R-E1R36N User's Manual
Removing the Heatsink
Warning:
We do not recommend that the CPU or the heatsink be removed. However,
if you do need to uninstall the heatsink, please follow the instructions below to uninstall
the heatsink to prevent damage done to the CPU or the CPU socket.
1. Unscrew the heatsink screws from the serverboard in the sequence as shown
in the illustration below.
2. Gently wriggle the heatsink to loosen it from the CPU. (Do not use excessive
force when wriggling the heatsink!)
3. Once the heatsink is loosened, remove it from the CPU.
4. Remove the used thermal grease and clean the surface of the CPU and the
heatsink, Reapply the proper amount of thermal grease on the surface before
reinstalling the heatsink. (Do not reuse old thermal grease!)
Loosen screws in sequence as shown.
Screw#2
Serverboard
Screw#1
Screw#3
Screw#4
Warning:
Do not reuse old thermal grease!
Memory Support
The X9DRi-LN4F+ supports up to 1.5 TB of LRDIMM (Load Reduced DIMM), 768
GB of RDIMM (Registered DIMMs) or 128 GB of UDIMM (Unbuffered DIMMs)
ECC/Non-ECC DDR3-1866/1600/1333/1066/800 SDRAM. For best performance,
install pairs of memory modules of the same type and speed. Please refer to our
website for any updates to supported memory. All channels will run at the fastest
common frequency.
DIMM Installation
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots starting with P1-
DIMMA1. See the Memory Installation Tables on the following pages.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Use your thumbs to gently press down on both ends of the DIMM module
until it snaps into place in the slot. Repeat for all modules.
4. Press the release tabs to the locked positions to secure the DIMM module
into the slot.
Warning:
Exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
5-5 Installing Memory
To Install:
Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-3. DIMM Installation
Top View of DDR3 Slot
Release Tab
Release Tab
Notch should align with the
receptive key point on the
slot.
Notch
Notch
Front View
Summary of Contents for 6047R-E1R36N
