Supermicro 6027TR-H70FRF, User Manual, Page: 96 / 134

6-14
SUPERSERVER 6027TR-H70QRF/H70FRF/H70RF USER'S MANUAL
Add-on Card/Expansion Slot Setup
The SC827 chassis includes I/O slots for add-on cards and expansion cards. Each
side supports one low profi le/half length add-on card for a total of four per chassis,
one per drawer.
Installing Add-on Cards (Figure 6-13)
1. Disconnect the power supply, lay the chassis on a fl at surface, and open the
chassis cover.
2. Pull open the add-on card slot clip in the rear of the chassis.
3. Slide the temporary PCI slot shield toward the slot clip and remove the
temporary shield from the chassis.
4. Connect the add-on card to the riser card.
5. Secure the riser card to the motherboard tray using the riser card screw.
6. Slide the add-on card bracket into the rear add-on card slot and secure with
the add-on card bracket screws.
7. Close the add-on card slot clip.
Note: Under normal circumstances, the riser card and add-on card bracket are
not separated.
Figure 6-13. Installing the Low Profi le Add-On Card
Riser Card
Bracket
Riser Card
PCI Slot
Shield
Add-on Card
Riser Card
Bracket Screws