26. Maintenance Alarm Setting
26.1 In Maintenance Alarm Mode the AGDO LED Courtesy Light will automatically start
flashing once a preset number of open/close cycles is reached.
26.2 To enable the Maintenance Alarm function press and hold down the “Set” button until
“1” is displayed on the LED screen. (Fig.11)
26.3 Momentarily press the “Up” button until “E” is displayed on the LED Screen. (Fig.28)
26.4 Momentarily press the “Set” button which will show the current Maintenance Alarm
setting.
26.5 Settings are “0” (Off) up to “5”. Each number above zero is a 1000 cycle increment. e.g.
“2” Maintenance Alarm will start LED Courtesy Light flashing after 2000 cycles.
27. Run Button Function
27.1 The AGDO has a Run Button function.
27.2
To open press the “UP” button. “n” will be displayed on the panel as the door travels to
the open position.
27.3 To close press the “DOWN” button. “u” will be displayed on the panel as the door travels
to the closed position.
28. Transmitter Battery Replacement
28.1 Remove the fixing screws located on the underside of the Hand-Held Transmitter.
28.2 Open the 2 halves of the Transmitter shell and replace the battery with one of identical
specification.
28.3 Test that the Red Coloured Indicator lamp illuminates when one of the Transmitter
buttons is pressed and then replace the fixing screws.
29. Wall Switch - Wireless
29.1 The wireless wall switch provides ease of installation without the need for running hard
wires to the switch and can be mounted in any convenient location.
29.2 The switch can be permanently screwed to the wall through the mounting holes
provided.
29.3 Use the mounting screws provided to fix the Wall Switch to the wall.
29.4 The wireless wall switch may be learned into the AGDO as per the procedure outline in
Sec.12.2, “To code a transmitter”
29.5
Important Note: The wireless Wall Switch must be mounted within sight of the garage
door and a reasonable distance away from moving parts. It should be mounted at least
1500mm above the ground
.
30. Wall Switch-Wireless Battery Replacement
30.1 Remove the cover plate while the unit is still mounted to the wall by sliding and twisting a
straight screwdriver in the slot provided on the top and underside of the wall plate.
30.2 Use a small Phillips Head Screwdriver remove the 4 screws holding the switches in place.
30.3 Replace the battery with one of identical specification.
30.4 Test that the Red Coloured Indicator lamp illuminates when one of the Transmitter
buttons is pressed and then replace the fixing screws and cover plate.
SETTINGS & ADJUSTMENTS
Fig.28
