25. Installation and Enabling of Safety Beams (Optional)
Installation
25.1 Locate the Safety Beam Mounting Brackets provided.
25.2 Mark the inside door framing so that the bottom edge of the Mounting Brackets sits
125mm off the floor.
25.3 Use the 2 mounting screws provided to fasten each Mounting Bracket to the wall. Do not
over tighten the fixing screws as the Mounting Brackets will need to undergo adjustment
later.
25.4 Use the 2 screws and nuts provided to fasten the Safety Beams to the Mounting Brackets
so that the Indicator Lamp on each Safety Beam is facing upwards.
25.5 Using 3 Core Cable, strip back and connect 2 strands to the Emitter and 3 strands to the
Receiver. (Fig.26)
25.6 Securely fix the cable up and along the wall and run one length of each cable adjacent to
the Rear Cover.
25.7 Strip back and connect one strand of each cable to the terminals marked “24V”, “PE” &
“GND”. (Fig.26)
25.8
Note: Superlift Safety Beam kits will have full instructions on mounting and connecting.
Enabling
25.9 To enable safety beam function press and hold “Set” button until “1” is displayed on the
LED screen. (Fig.11).
25.10 Press “Up” button until “d” is displayed on the LED screen.
25.11 Momentarily press the “Set” button. If “0” is displayed photo
beams are not enabled. Momentarily pressing the “Up” button will
change the LED to display “1”. Photo Beams are enabled.
25.12 Initiate a closing cycle on the AGDO and as the Garage Door is closing
pass your hand through the line of the Safety Beams. If the Safety Beams are functioning
correctly the AGDO should stop and then immediately reverse direction.
25.13 If the Garage Door does not commence to close at all, check that the Safety Beams are
aligned correctly.
25.14
Important Note: The AGDO will only support the fitment of Superlift Brand 4 wire
Safety Beams.
25.15
Note: If safety beams are not fitted, ensure that “0” is displayed and safety beam
function is disabled.
SETTINGS & ADJUSTMENTS
Emitter
Receiver
Fig.26
Fig.27
