19
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
WARNING
The blower must be plugged directly into a properly
grounded three-prong receptacle, 120 VAC, 60 Hz, single
phase. Do not cut or remove the grounding prong from
this plug. Do not route power cord under or in front of
appliance.
Installation must be in accordance with National Elec-
trical Code, ANSI/NFPA 70 - latest edition. In Canada,
the current CSA C22.1 Canadian Electrical Code - latest
edition.
DANGER: Disconnect power before servicing blower.
WARNING
In the event that you remove the blower for any reason, the rear heatshield must be returned to its original condi-
tion or replaced before using the heater. Excessive rear wall temperatures will result if the stove is burned with the
blower opening unobstructed.
Figure 24
The optional blower is controlled by a Dial-a-Temp
(see
Figure 24
)
. It
contains an On/Off line switch with variable speed control from low to
high.
1) Install the optional blower kit per the instructions provided in the
blower kit.
2) Plug the blower power cord into the receptacle on the bottom of the
Dial-A-Temp.
3) Plug the connected Dial-A-Temp into a properly grounded, 120 VAC
wall outlet.
4) To operate, rotate the dial on the Dial-A-Temp clockwise until it clicks
on. Rotate the dial further clockwise for a lower speed, then counter-
clockwise for a higher speed.
NOTE: Turn blower off before opening the door to load the fuel.
OPTIONAL BLOWER KIT
HIGH
LOW
OFF
Blower Assembly
OPTIONAL BLOWER KIT
Dial-A-Temp
(on/off and blower
speed control)
Wall Outlet
1) Plug power cord
into the bottom of
Dial-A-Temp.
2) Plug Dial-A-Temp
into wall outlet.
Summary of Contents for WXS2021WS
Page 26: ...26 NOTES...
