4
oThER FEATURES / TELETEXT / TIPS
increase. By decreasing the volume level in mute state,
mute will not be ignored, only the volume level will
decrease. If mute canceled after decreasing the volume
level, the volume will valid with the decreased level.
No-Signal
No-Signal Timer Indicator
• It is displayed in the middle of the screen when no va-
lid signal detected. It shows the remained time for the
switching to the Stand-By mode (it takes 5 minutes
when any signal detected or no any Remote Control
command is accessed). The indicator is displayed in
seconds when there is no valid signal.
• After an Remote Control command (if No-Signal
Timer is active) the timer stops and if no signal
detected again the timer is initialized to 5 minutes
and starts seconds later again to count down.
• It is not valid in AV mode.
Blue Background During No-Signal
In case, no valid signal is detected (in AV mode)
Blue Background is activated.During search process
Blue Background is not active. But instead of it there
is another feature given; the semi-transparent menu
background is made blue.
volume Bar
It is displayed in the lower middle of the screen. When
a volume command is received (pressing
v+
or
v-
by
Remote Control or Front panel) and no menu is active, it
stays on the screen for seconds, after the last volume
command or until another command is received in
between.
Av Modes
By pressing the “
Av
” button you can switch your TV
to AV modes (except being in Teletext). Pressing this
button consecutively will switch the TV in one off the AV
modes: AV1, AV2, RGB, SVHS or FAV (Front AV). The
SVHS mode is dedicated to the AV2 mode. If there is
no AV2 mode in your TV, at the same time there is no
SVHS mode too.
AV1 supports the RGB mode and AV2 supports the
SVHS mode. But if there is some colour problem in AV1
or AV2 modes, please force the AV mode to RGB or
SVHS mode.
In order to quit the AV mode press the “
Tv
” button.
TELETEXT
• Teletext is an information system that displays text on
your TV screen. Using the Teletext information system
you can view a page of information on a subject that
is available in the list of contents (index).
• On screen display is not available in text mode.
• Contrast, brightness or colour control is not availa-
ble, but volume control is available in text mode.
To operate Teletext
• Select a TV station on which Teletext is being trans-
mitted.
• Press
(TELETEXT)
“
TXT
” button. Usually the list of
contents (index) is displayed on the screen.
To select a page of Teletext
• Press the appropriate digit buttons for the required
Teletext page number.
• The selected page number is displayed at the top
left corner of the screen. The Teletext page counter
searches until the selected page number is located,
so that the desired page is displayed on the screen.
• Press „
P+
“ button to move the Teletext screen
forward one page at a time.
• Press „
P-
“ button to move the Teletext screen back-
ward one page at a time.
To exit Teletext
• Press “
Tv
” button. The screen will switch to TV
mode.
TIPS
care of the Screen
Clean the screen with a slightly damp, soft cloth.
Do not use abrasive solvents as they may damage the
TV screen coating layer
Poor Picture
Have you selected the correct TV system? Is your TV set
or house aerial located too close to the loudspeakers,
non-earthed audio equipment or neon lights, etc. ?
BDA_Superiour_SPM5521.indd 34
26.03.2007 15:54:51 Uhr
