HEATFLOW CONVECTION KIT INSTALLATION
This wood burning fireplace is approved for use with a HeatFlo Convection
Kit (hot air ducting system).
NOTE
: If the Clean Face facade is to be used, a HeatFlo Kit designed
specifically for this fireplace MUST be installed. See INSTALLATION AC-
CESSORIES section for available kits.
KIT CONTENTS (See
Figure 20):
The Ducted Flex Kit must use both hot air outlets and includes:
2 ea. Wall Thimble Assembly (item #1)
2 ea. Duct Adaptor (item #2)
2 ea. Duct Ring (item #3)
8 ea. #6-18 X 2 Drywall Screw (item #4)
22 ea. #10-16 X 3/4” Hex-Unslotted Drive Zinc Finish
Self-Drilling Screw (item #5)
2 ea. 2 Ply 8” Dia. X 10’ Aluminum Flex with R4 Insulated Sleeve (item #6)
2 ea. Grill, White (item #7)
4 ea. #6-18 X 1-1/2 White Oval Head Zinc Plated Phillips Screws (item #8)
1 ea. Instruction Sheet
TOOLS NEEDED:
5/16” hex driver and no. 2 Phillips screwdriver
EPA Fireplace - HeatFlo Convection Kit
Cat. No.
Model
Description
F3790
EPA-HEATFLO-KIT
EPA Heatflo Conv. Kit
Table 2
GENERAL INFORMATION
If you encounter any problems, need clarification of these instructions
or are not qualified to properly install this kit, contact you local distribu-
tor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
Figure 20 - General Assembly
2 Ply 8" Dia X 10' Aluminum Flex With
R4 Insulated Sleeve (Qty 2)
See
Detail A
See
Detail B
(Item #6)
#6X1-1/2 White Oval
Head Zinc Plated Phillips
Screw (Qty 4)
Wall Thimble
Assembly
(Qty 2)
Grill White (Qty 2)
#6-18 X 2" Drywall
(Qty 8)
Detail A
Duct Adaptor
(Qty 2)
#10-16 X 3/4" Hex-Unslotted
Drive Zinc Finish Self-Drilling
Screw (Qty 22)
Detail B
Duct Ring
(Qty 2)
(Item #5)
(Item #3)
(Item #2)
(Item #7)
(Item #8)
(Item #4)
(Item #1)
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
17
