SuperiorFireplaces.us.com
127029-01F
12
REFRACTORY PANEL INSTALLATION
IMPORTANT: Installation of brick should be done after
the fireplace is placed in a permanent location.
1. Remove screen assemblies and all hardware components out of
the firebox. The bottom panel is preinstalled in the firebox. Make
sure the bottom refractory panels is centered in the firebox and
flush with the front of the fireplace.
2. Place cardboard on top of bottom refractory panel as a protection
to prevent shipping and scratching during installation of the other
panels.
3. Install rear refractory panel. This panel has a top and bottom. To
determine which is which, match up the pattern on the rear panel
with the left and right sides before installing the rear panel. Make
sure panel is center before continuing.
4. Install the right and left refractory panels with the gas line knock-
outs orientated down toward the bottom refractory. Align the left
and right panels with the rear panel so the grout lines line up.
5. Install the upper corner brackets and tighten set screws
(
Figure
13
).
INSTALLING FIREPLACE HOOD AND SCREENS
1. Attach hood to firebox using screws provided
(see
Figure 14
).
1. Slide round end of screen rod into rings at top of screen. Attach one
push-on nut to end of rod before attaching last ring of screen.
2. Insert the round end screen rod into hole on the left and right side
of smoke shelf
(
Figure 15
).
3. Mount flat end of screen rod with #10 x 5/8" to center of smoke
shelf.
4. Install other screen rod in same manner.
INSTALLATION
Continued
Figure 14 - Screw and Hood Placement
Screws
Figure 15 - Installing Fireplace Screen
Rating
Plate
Hole for Screen
Rod
Leading
Bricks
Figure 13 - Installing Refractory Panels
LEFT BRICK
PANEL
PANEL
RIGHT BRICK
REAR BRICK
PANEL
BOTTOM
BRICK PANEL
ASH PANEL
UPPER CORNER
BRACKET (2x)