User Manual
Part Number:
Installation Instructions
LED-Ready Landscape Lights
Important: Read all instructions prior to installation.
Rev Date: V0.1 07/23/2018
SBL Part No. Description
WWN-2212
Silicone Filled Wire nut
SFT-20
Self Fusing Silicone Tape
WP14-2DB
14 Guage Landscape Wire
WP12-2DB
12 Guage Landscape Wire
Safety and Notes
Parts Included
Recommended Accessories
Assembly
1- Low Voltage Path Fixture (bulb not included)
1 - Mounting Stake
Note: Bulbs must be purchased separately.
LSBF lights require an MR16 bulb. LSFF lights
require a G4 bulb.
1.
After assembly, lay fixtures out as they will be installed.
2. Run landscape wire (WP14-2DB or WP12-2DB available at
superbrightleds.com) from 12 V supply past each light. Wire must be
within 30” of mounting stake to allow power connections to be made.
1. Install bulb (purchased separately).
LSBF
- Turn the top of the housing counterclockwise to release and gently pull
apart. Install MR16 bulb and reinstall top housing.
LSFF
- Unscrew 2 lens retaining screws. Install G4 bulb and replace lens.
2.
Run cable through stake and thread fixture into it.
3. Properly connect each light to landscape wire. Wrap all connections
in self-fusing tape (available at superbrightleds.com).
4.
Using a trowel (and water as needed), loosen ground where fixture will be
installed. Gripping the stake ONLY, press stake into ground.
Caution: Do not use a hammer or exert force on fixture itself during
installation as doing so may cause damage.
5.
Turn on 12 V supply and ensure all fixtures are
working. If there are any issues, refer to the
troubleshooting guide in this manual.
Power
Supply
LSxF-BZ
• For use with OUTDOOR, low-voltage landscape lighting systems ONLY.
• Do not submerge in water—NOT FOR USE with submersible or pool/spa equipment.
•
This light fixture is only suitable for a 12–15 Volt AC or DC power supply. Do not exceed 80% of power supply max output.
• Use appropriate landscape wire (SBL product numbers WP14-2DB or WP12-2DB)
• Spikes are very sharp, handle with care.
• The images shown are for illustration purposes and may not directly represent all models.
6. Dig a small channel—depth of 3” is
recommended—and bury landscape wiring and
connections. Stone and mulch are also
suitable coverings.
LSBF-BZ
LSFF-BZ
LSBF-BZ
