Operating Instructions:
© Supera,
2015
Version 2
|
July
2015
| Griddles
Page 7
www.SuperaCo.com
Operating the Griddle - Pilot Lighting Instructions for
Manually-Controlled
Griddles
Before operating the
griddle
, it should be checked to see that it is sitting level. Adjust the feet to level the
griddle
. Be sure
the catch tray has been properly placed.
The pilot light on the appliance have been set at the factory. Each burner has a pilot light.
1. Make sure all knobs are in the
“OFF”
position.
2. The main gas valve should be
“CLOSED/OFF”
for five (5) minutes prior to lighting pilots to clear any existing gas.
(Main gas valve is supplied by others.)
3. Turn
“ON/OPEN”
the main gas valve to the unit.
4. Light and hold an ignition source (match) at the pilots. When the flame is established, remove the ignition source.
Repeat this step for each burner as each burner has its own individual pilot.
The pilot can be reached through the holes on the front of the unit.
5. Turn each burner knob
“ON”
. If the burners do not ignite promptly, turn the knobs
“OFF”.
From the opening in the
front panel, use a screwdriver and turn the pilot valve screw counterclockwise which will increase the flame height
and repeat step 4.
If the pilot flame appears larger than necessary, turn it down and reset burner ignition. The pilot flame should be as
small as possible but large enough to guarantee reliable ignition of the burners when the knobs are turned to
“ON”
.
The holes located in the front panel are pilot valve adjustments. Use a screwdriver to turn the valve to adjust the flame
height to your desired level.
All burners are lit from constantly burning pilots. Turning the valve to the desired flame
height is all that is required to put the unit in service.
Shutdown:
Turn the unit off by rotating the gas control knob clockwise to the
“OFF”
position.
The pilot light will remain lit.
To extinguish the pilot light completely, verify the gas control knob is
“OFF”
and turn
OFF/Close
the main gas line connec-
tion to the unit.
To reignite the pilot light, repeat the above steps.
