19
ENGLISH
Ignition system operations
If the ignition system fails to ignite the burner, light
the burner with a match. If the burner lights with a
match, then check the ignition system.
•Check that both the white and black ignition wires
are attached properly.
•Check that the ignition button pushes the igniter
(button) down, and returns to the up position.
If the ignition system still fails to light, contact the
Customer Service Representative in your area.
And/ Or Nonuse
•When the Grill is not in use, the cylinder must be
DISCONNECTED and the cylinder stored outdoors in
a well-ventilated space.
•Disconnect the gas canister by turning counter-
clockwise until the canister fully release form the gas
inlet.
•Check the seals before connecting a new gas
container to the appliance.
•Change the gas container outside and away from
people.
Close the regulator inlet protection cap (Fig. 33 and
34) when your Grill is not in use.
•The Grill should be checked for gas leaks and any
obstructions in the burner tubes before using. (See
Sections: “Cleaning and Maintenance”)
•The Burner venturi section should also be checked
for any obstructions. (See Section: “Cleaning and
Maintenance.”)
Storage
Fig. 33
Fig. 34
PROBLEM
CHECK
SOLUTION
Burners do not light, or
flame is low in HIGH position.
Is LP cylinder fuel low or empty?
Is Igniter wet?
Does the burner light with a match?
Replace cylinder.
If you can light the burner with a
match, then check the ignition system.
Is there any air in the gas line?
Burner may take up to one minute
to light after a cylinder has been
connected.
Burners burn with a yellow or
orange flame, in conjunction with
the smell of gas
Is there blockage in the burner tube or
Venturi?
Clean Burner Tube. (See Section of
“Maintenance”)
Experiencing of flare-ups
Is the cooking grid heavily coated with
burned-on-grease?
Clean thoroughly. (See section
“Cleaning2)
Clean catch Pan
Burner flame pattern is erratic.
Flame is low when burner is on
HIGH. Flame does no run the
whole legth of the burner tube
Is the burner clean?
Clean burner. (See section
“Maintenance”)
Is LP-cylinder Pressure low?
Replace cylinder
Is outdoor temperature less than 40ºF
and LP cylinder less than ¼ full?
Replace with a full cylinder
Is fuel flow restricted?
Check burner and orifices for blockage.
Adjust control knob to full ON position.
Burner does not light when igniter
button is pushed.
Is burner tube positioned is too far
away from the igniter box?
Check that the burner tube is
positioned correctly over the igniter box.
(See section “Maintenance-Replacing
the burner tube)
Burner flame does not ignite
completely around the burner
tube.
Are the burner ports clean and fully
open?
Clean burner. (See section
“Maintenance”.) Use a small paper clip
to unclog any dirty ports.
Burn won’t stay lit.
Is dust and/or dirt built up around
burner?
Clean dirt and/or dust from around
burner ports.