18
ENGLISH
Replacingburner tube
1. Your Grill must be OFF and cool.
2. Unscrew and remove propane cylinder from
the hose assembly.
3. Open the lid.
4. Remove cooking grid.
5. Unscrew and remove the screws and stainless
steel washers that hold the burner tube inside
the Base Pan (Fig.30).
6. Carefully slide the burner tube out from the
Base Pan.
CAUTION:
The burner opening 1 must be positioned properly over
the valve orifice 2.(Fig.31)
7. To reinstall the burner, reverse procedure 5
through 7.
Important:
Make sure the Orifice 2 (Fig.31) is fitted into the
Burner Opening 1 (Fig.31) and Igniter port hole A
(Fig.32) lines up with the arrow tab on the igniter
box B (Fig.32).
DANGER
Failure to follow the above mentioned procedures,
may result in a fire, which cause serious bodily injury
or death, and cause damage to property.
• If the Grill has been left uncovered and is wet from
rain, snow, yard sprinklers, etc., allow to dry (at least
30 minutes prior to use).
NOTA: In a salt-air environment (such as near an
ocean), corrosion occurs more quickly than normal.
Frequently check for corroded areas and repair them
promptly.
Burner flame pattern
The Grill burner has been factory set for the correct
air and gas mixture. The correct flame pattern is
shown. (Fig.28)
If the flames do not appear to be uniform
throughout the burner tube, follow the burner
cleaning procedures.
Burner Tube Cleaning Procedures:
Turn off the gas supply. Remove the burner tube. (See
Replacing Burner Tube) Look inside the burner with
a flashlight. Clean the inside of burner with a wire (a
straightened-out coat hanger will work).(Fig.29)
Check and clean the valve orifice (Fig.31) inside the
rear end of Base Pan. Use a steel bristle brush to
clean outside of burner. This is to make sure all the
burner ports are fully open.
DANGER
Do not enlarge the burner ports when cleaning. Any
modification of the appliance may be dangerous.
Fig. 29
Fig. 28
BIEN
Tips occasionally
flicker yellow
Yellow
Blue
Dark blue
Light blue
Burner tube
MAL
Fig. 30
1. Agujero
de la
válvula
2. Apertura
del
quemador
Fig. 31
Fig. 32
Encendedor
B
A
Holes in Burner