Super B 9000 000 00010, Manual, Page: 5 / 40

NOT_TOUCH_SB-01
TECHNICAL MANUAL
EN
AUTOMATIC IDENTIFICATION
If case of a battery with an ID010, the Touch goes into an automatic identification mode
If a problem occurs during the identification (or if several batteries have the same ID), press Exit
and then Start Scan during 10 to 15 seconds. A new automatic identification can start again.
Start Scan
69 %
CHARGE
25A 13V
CURRENT
2h
UNTIL CHARGED
STATUS OK
Select view
Battery
Bank
Bat - 1 Bat - 2
Battery
Over view
Bank
Settings
Bat - 1
AUTOMATIC IDENTIFICATION AUTOMATIC IDENTIFICATION
AUTOMATIC IDENTIFICATION
Select the number of batteries
connected to the park
and validate
Connect only one battery
and validate
Connect the second battery
and validate
2
!!! Warning, the identification is done battery by battery. The first battery is connected, the
identification done, then the second, then the third, etc.… A 120 Ohms resistor is plugged on
the communication port of the battery during the identification.
Exit
Exit Exit