SupaVu DVR16D1, Installation And User Manual

Page: 35 / 73

35
search for video between 1 am and 2 am, the recorder may not operate properly
because there will be two hours of recorded video during this time period. To
view video during this overlapping time period, you must start playback before 1
am, then recorder will play both hours between 1 am and 2 a.m. You cannot do
a backward search through the overlapping time. But, you can do forward
search.
Video Type (
⑤
)
Video Type can set in this menu without rebooting or initialisation. The default is PAL, NTSC
can also be selected.
System ID (
⑥
)
The remote control can be used to control up to 16 DVRs,
the ID number on each can be set to a unique address so
that the remote will only control one at a time if they are in
close proximity. The default is 11.
To select a unit on the remote control press the ID button,
followed by the number, followed by the ID button again.
The LED will flash slowly.
Key Beep (
⑦
)
The buzzer can be set to sound on whenever the button on the front panel or remote
controller is pressed.
Factory Default (
⑧
)
All the menu settings will be returned to the factory default. To carry out this function the
system recording will have to be turned off.
Disk Format (
⑨
)
Formatting of the drive is used when new drives are installed or you need to wipe all
information on the disk.
Program Update (
⑩
)
Always turn off : Playback and Network access while upgrading the unit
The latest firmware version can be upgraded through USB 2.0 Port using Memory Stick or
CD/DVD Media. When a memory stick is connected to the USB port, this symbol
will be shown in the status bar of the screen.
Click the SEL. If the system recognizes the new firmware then, “Confirmation window” will
be displayed on the screen.
Next click the “SEL” on the confirmation window. Processing percentage will be displayed.
The message window will be displayed on the screen after upgrading the program.
Click “POWER” on the message window, the DVR will be rebooted.
Smart (
⑪
)
This function is used to keep a check on the health of the Hard disk. The parameters which
can be monitored are:
1. Read/Write errors on the drive
2. Drive temperature.
Smart : Turn to on to enable feature.
LED