SUPAIR _
EONA
2
page 8
EONA
2 glider user's manual
Connecting the glider
Opening the wing
Without twisting the risers, connect them to the harness connection loops using the self-locking
carabiners.
Check for the risers to be properly positioned and untwisted. The "A" risers must be located at the
front and facing the flight direction( see schematic ).
Lastly, check for the main self-locking carabiners to be fully closed and locked in place.
Risers
Self-locking
Carabiners
Harness :
Flight direction
Choosing an adapted harness.
It is advised to adjust the harness's chest strap width based on your wing size :
42 cm for an EONA2 size XS
42 cm for an EONA2 size S
46 cm for an EONA2 size M
46 cm for an EONA2 size ML
48 cm for an EONA2 size L
Install the accelerator according to your harness manufacturer's
recommendations.
Connect it to the wing using the split hooks.
Once the accelerator/speedbar is connected, adjust its length
according to your measurements. For correct use, there must not be
any tension at the split-hook level when the accelerator/speedbar
line is relaxed.
Red : left riser
Green :
right riser
Choose a flat or lightly angled training hill without obstacles or wind.
Open your wing and arrange it in a crescent shape.
Check the fabric and the lines for any sign of wear or damage. Check for the links connecting the lines
to the risers to be fully closed. Identify, separate and arrange the A,B.C, risers as well as the brake
lines neatly. Knots or tangles can not be present.
The EONA2 glider was certified EN A with a EN1651 & LTF certified harness and hence can be flown
with most harnesses models found on the market today. We wil advise you to choose a EN1651 and or
LTF certified harness with a built-in dorsal protection system.
Connecting the wing to the harness.
Harness chest strap spacing
Installing the accelerator
