SUP'AIR manufactures its products in Europe. Most of the components used are Made in Europe.
S
UP’AIR
_
A
CRO
3
Page 10
ACRO 3 manual
C
BUMPAIR assembly
Accessing the Bumpair pocket.
1.
Lift the Velcro® flap located above the shoulder strap.
2.
Fully open the Zip found under the flap ( not to be mistaken for the storage dorsal pocket zip ).
3.
Insert the Bumpair starting from its thickest section. Push it all the way in for a secured placement by following its contour by hand inside its housing.
4.
Place the upper holding pocket hood over the Bumpair.
5.
Fasten the Zip and finally the Velcro® flap.
Accessories assembly
Velcro®
Zip
The BUMPAIR is only installed once. There is no need to take it out of its container afterward unless in case of a severe impact
or water landing : it would then be necessary to inspect it for possible damage ( tear, ripped fabric or stitching, etc. ).
