SUOMY TX-PRO TRACK-1, User Instructions

Page: 31 / 82

EN
Adjustment — Figure 15
If after replacing the part, or after long use of the helmet, you
experience infiltration from the closed visor, it may be necessary to
adjust the mechanisms of the visor.
Lift the visor until it is completely open.
Remove the visor, as specified in the previous paragraph.
Loosen the two screw (R - S) without removing them and without
disassembling the mechanism.
Shift horizontally the whole mechanism and tighten the screws.
Repeat the operations on the opposite side by shifting the
mechanism on the same direction of the previous one.
Once finished, check if the visor can be easily closed and if it
adheres to the gasket.
VISOR MECHANISM
Replacement — Figure 16
Removing the mechanism
After removing the visor as indicated in the paragraphs above,
loosen and remove the screws (R - S); then remove the mechanism
from the shell.
Fitting the mechanism
The mechanisms are not interchangeable. Before proceeding it is
necessary to identify the correct assembly side;
Put the mechanism on the shell, insert the screws tightening them.
After fitting the parts verify that the mechanisms are positioned
correctly and tightly fixed to the shell. Then fit the visor and adjust
it as specified in the above paragraphs.
After fitting the mechanism verify that the visor is tightly fixed to
the helmet, that it rotates freely and that it locks correctly into the
locking positions.
If this doesn’t happen and the rotation mechanism of the visor
doesn’t work correctly, do not use the helmet and contact
authorized Suomy personnel only.
FIGURE 15
R R
S
S
FIGURE 16
R
S
31