Note: Equipped with cable type only.
3-2. Factory Settings
NAVI mode
PRO mode
Item
Response time
Hysteresis
Amount of shift during limit teaching
M.G.S.
Emission halt
Display switching
Display turning
ECO mode
Period hold
Selection for transmission change to permit / not to permit
External input switch setting (Note)
Backup setting (Note)
Code setting
0-adjust setting
Output 1 / 2 sensing mode
Settings
STD (standard)
H-02 (standard)
15 %
Level 3
Laser emission ON
Incident light intensity display only
Digital display turning OFF
ECO OFF
Hold OFF
Lock OFF
Emission halt
OFF
00000000
OFF
Normal mode
Digital display
Item
Threshold value
Output operation
Timer operation
CUSTOM mode display
Settings
Output 1: 40, Output 2: 60
L-ON
L-ON (Output 1
Output 2)
Without timer (Output 1
Output 2)
Response time change
Output 1: , Output 2:
Digital display
Factory settings for the LS-400 series are indicated below:
If the amplifier is reset using the ‘9-4 Setting Reset Function’ from ‘PRO5 Mode’ on p. 50, the resulting settings
will be those indicated below:
Operation protection
You can use the ‘key lock function’ to protect these operations. (Refer to p. 56.)
Key lock function
This function can be used to prevent the operator from accidentally changing the sensor settings.
Automatic interference prevention function
To operate the automatic interference prevention function, you need to install the amplifiers so that they are
directed against each other and carry out optical communication.
The automatic interference prevention function allows up to four sensor heads to be installed so that they are
directed against each other.
(However, the automatic interference prevention function cannot be used in H-SP mode.)
Output switching
Set the sensing mode (PRO6) for output 1 to normal mode beforehand.
In modes other than normal mode, this is fixed at output 1.
Press the MODE key for more than 2 seconds when in NAVI mode. If Output 1
has been selected, the Select 1 indicator (yellow) lights up. If Output 2 is being
selected, the Select 2 indicator (yellow) lights up.
Select 1 indicator
(Yellow)
Select 2 indicator
(Yellow)
4
