WSU43+
06.
05.
Camera Angle Adjustment
When rotating the camera:
Please hold the license plate holder with one hand, and rotate up or down
the camera with the other hand to make the best Angle.
The parking guideline position can be adjusted
up or down, to mark the image area more realistic.
There are 5 levels for choice.
5 levels of adjustment
For detailed operation methods,
please refer to page
P12.
2. Parking Guideline Position Adjustment
1. Please vibrate the camera, power the monitor, touch the
Touch-Sensor
on
the monitor to show the rear image situation of car, then adjust the camera
angle accordingly to the most suitable position.
1. Switch the DC power port with car ignition, the monitor will start work
accordingly after touching the
Touch-Sensor
, the video signal
will be sent from camera and will
be displayed on the monitor.
2. If you want to see the backup image
when driving your car, just touch the
Touch-Sensor
on the top of monitor.
3. Connect the monitor and car ignition lighter hole with power cord.
Use L-shaped screwdriver to
tighten the vent screw
Make sure the cross position of the
threaded base is correctly inserted
into the cross groove of the monitor
Insert the ball into the nut
Press the vent mount ball inside
the thread ed base forcely
Rotate the nut and tighten it clockwise
By lifting up and down, the clamp
can clamp or loosen the vent
- 7 -
- 8 -
3) The monitor can be mounted on the air outlet of the air conditioner in the
car, allowing drivers to share the mobile phone bracket, and can avoid
traf
fic violations (some country traf
fic laws do not allow the windshield or
the center console to be installed anything to block the driver's view sight).
Please follow the steps:
