Synway Information Engineering Co., Ltd
SMG Series Analog Gateway User Manual (Version 1.5.3)
Page 82
Figure 3-92 are all factory settings. The IP Address for LAN 1 and that for LAN 2 cannot
be in the same segment.
2. LAN2 is disabled by default for the gateway Version 1.3.3 or above. If you want to use
LAN2, please log in the gateway through LAN1 first, and then modify the network
settings to enable LAN2.
After configuration, click
Save
to save the above settings into the gateway or click
Reset
to
restore the configurations. After changing the IP address, you shall log in the gateway again using
your new IP address.
3.9.3 Upgrade
Figure 3-93 Upgrade Interface
See Figure 3-93 for the upgrade interface where you can upgrade the WEB, gateway service,
kernel and firmware to new versions. Select the upgrade package “*.tar.gz” (The gateway will do
MD5 verification before upgrading and will not start to upgrade until it passes the verification.) via
Browse…
and click
Update
.
Then the file uploading interface will appear. See Figure 3-94.