1.
Insert the electrode
(H)
through
PP Electrode Protective Housing
(G)
2.
Rinse the electrode
(H)
properly so that it can be easily passed through Rubber electrode
holder
(I)
,
with about 5cm left below.
3.
Install the prepared
Rubber electrode holder
(I)
into PP Electrode Protective Holder
(G)
and
fix PP pipe protective cover
(J)
tightly.
4.
Insert the Electrode cable
(H)
through
Lower cover of round junction box
(D)
and Cable
fixing gland
(C)
, and use Lower cover of round junction box
(D)
to fix PP Electrode
Protective Housing
(G)
tightly.
Note:
The (F) O-shaped ring should be fixed into a glove on PP Electrode Protective Housing
(G)
correctly.
5.
Prepare 15cm cable in the PP pipe, and then fix Cable fixing gland MG16A
(C)
tightly. Leave
electrode cable
(H)
for about 12-14cm, and split it carefully.
6.
Fix the terminal of electrode coaxial inner on terminal block 1 of round holder; Fix the
terminal of electrode coaxial shield on terminal block 3. (See the instruction of junction box)
7.
Extend the cable to pass through Cable fixing gland
(E)
on Lower cover of round junction
box
(D)
, and fix Cable fixing gland MG16A
(E)
tightly, leaving 12-14cm in the box for split.
8.
Extend the lead coaxial inner and electrode coaxial inner to connect them; extend the lead
coaxial shield to fix on the terminal block 3. Tight up
Upper cover of round junction box
(A)
to finish the installation.
Note:
The (B) O-shaped ring should be placed below the round junction box
(D)
correctly.
Installation of holder support base
The L-shaped electrode holder support base is installed by finding an appropriate position in
the edge of a pool according to the field’s requirements with nails or expansion screws.
A------Holder U-shaped clamp
B------Immersive holder (PP-100A)
C------Holder fixed plate
D------Support base
E------Plastic screws
8-26-7: Plastic L-Shaped Electrode Holder Support Base
7202-00416A: Stainless L Shaped Electrode Holder Support Base
4