Doc. Title
ST3940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST3940
1.06
0
18-6-19
20 of 54
● The following table shows how to set intervals of location report, alert and how to set sensor value to sense if any
motion is made.
HDR
DEV_ID
VER
MOVING_STOP_INTRV
MOVING_INTRV
EMERGENCY_INT
EMERGENCY_ALERT_NUM
EMERGENCY_ALERT_THRES
PRM_ENABLE
Field
Marks
Value
Meaning
HDR
“ST600RPT”
Command type.
DEV_ID
10 char
Device ID.
VER
“02”
Protocol Version
MOVING_STOP_IN
TRV
String
Second
Sending interval of location report while Moving stop.
Range : 0, 5 to 86400
If zero, the device doesn’t send location report periodically.
MOVING_INTRV
String
Second
Sending interval of location report while Moving.
Range : 0, 5 to 60000
If zero, the device doesn’t send location report periodically.
EMERGENCY_INT
String
Second
Sending interval of alert about carrying out
Range : 0, 5 to 180
If zero, checking of carrying is disabled.
EMERGENCY_ALE
RT_NUM
String
Number of attempts to send an emergency report until the
device gets acknowledgement from the server.
If 0, no Emergency Report will be sent.
If 65500, unlimited report until get ACK from Server.
EMERGENCY_ALE
RT_THRES
String
Threshold value of the sensor to check if movement of the
object is made.
Range: 0.0 to 1.9
However, it is highly recommended that the value should be
0.10.
PRM_ENABLE
‘0’ / ‘1’
PRM report is enabled on parameter report, including device
IP information assigned from PDP when connected on UDP
‘0’ : Disable
‘1’ : Enable (Default)
