Operation
•
After switching on or switching over, the fan runs. The compressor and cooling capacity start as soon
as the set temperature in cooling mode is lower than the room temperature. During heating mode the
compressor and heating capacity start as soon as the set temperature is higher than the room
temperature.
•
To not damage the compressor, wait at least 3,5 minutes before turning on the unit.
•
Operating voltage: 220-240V~, 50Hz
•
Control panel:
1.
On/Off („POWER“)
2.
Temperature – („DOWN“)
3.
Operation mode („MODE“)
4.
Timer („TIMER“)
5.
Temp („UP“)
6.
Ventilation speed („SPEED“)
Indicating lights operation modes:
7.
Dehumidification
8.
Cooling
9.
Heating
10.
Signal receiver remote control
Indicating light ventilation speeds:
11.
Medium
12.
High
13.
Auto mode
14.
Low (Low Mode)
15.
LED-display
•
Remote control:
1. SPEED:
Ventilation speed
2. TEMP+:
Tempe
3. MODE:
Operation mode
4. TEMP-:
Temperature -
5. TIMER:
Timer
6. POWER: On/Off button
Operation with 2 x AAA batteries (excl. scope of delivery)
•
Environmental temperature for cooling function: 18°C – 35°C
Environmental temperature for heating function: 15°C – 25°C
•
Make sure that the exhaust hose is installed properly before operation, then plug in the unit, but do not
use a multiple socket. Press „POWER“ to turn on the unit. When pressing the button again, the unit will
enter the standby mode.
•
LED display:
o
The LED display indicates the set temperature in °C or the set timer. Possible error codes are
also shown on the LED display.
•
Operation mode cooling:
o
When the refrigeration function is carried out, the exhaust hose should be placed outside the
window so that the hot air can be discharged.
o
Press „MODE“ until the indicating light for cooling lights up.
o
Press the buttons „UP“ und „DOWN“ to adjust the desired room temperature between 17°C und
30°C.
o
For optimal cooling, make sure that curtains are closed to avoid direct sunlight entering the
room. Ensure that the unit is not placed near heat sources.
