11
the appliance by yourself.
Warning:
In order to avoid overheating, do
not cover the heater!
Important
: This heater is equipped with a temperature
control unit. Please do not operate the unit near people
who cannot move independently be, unless they are
supervised throughout.
Components / Scope of supply
Screw M6 * 50 (2 pieces)
Cable clip
Equipment base
Screws Nuts (2 pieces)
Base cover
Screw M4 * 28 (2 pieces)
Equipment housing
Allen key
Installation
•
Please place the device on the head (Figure A). Connect the plug (8) and the power cord through the holes
in the center of the base cover (3) and the base (2). Mount the base cover (3), the base (2) and the screw
nuts (6) on the main body.
•
Fasten the two screw nuts (6), the base (2) and the base cover (3) using the screws M6 * 20 (1).
•
Secure the power cable with the clip (5) at the base and screw the cable clip with the screws
M4 * 35 (7) fixed, as shown in the picture B.
Figure A
Figure B
Commissioning
•
Operating voltage: 220-240V~, 50Hz, 1700-2000W
Please connect the unit to the power.
•
Please return the power switch (on the top
the unit) in the "I" position; the indicator light flashes red.
•
Please press the "MODE" button (9) to switch between the following heat
settings:
Low (low, the indicator lamp lights green),
medium (medium, the indicator lamp lights orange)
High (high, the indicator lights up red).
•
Please press the button "OFF" to disable the device.
•
Please return the switch to the "O" position.
Remote control
With the supplied remote you can control the device as follows:
On
Off
