CONTROL SWITCH
POSITION NO.
APPROXIMATE
HUMIDITY SETTING
8
2
0﹪
7
3
0﹪
6
4
0﹪
4
6
0﹪
2
8
0﹪
Turning off the unit
1. Turn the humidity control switch to the left side to the “OFF” position and the power supply is cut off and the unit stops in
operation.
2. If the dehumidifier is not in use for a long time, please disconnect the power cord plug from the outlet.
PRECAUTIONS
1. The dehumidifier shall not operate if the humidity setting is higher than the ambient humidity.
2. Drain the water in the water storage tank when the water in the tank is full and the water level indicator light illuminates.
And then install the empty water tank back to its position, so the unit can continue its operation.
3. When the unit stops, you have to wait for 3 minutes before you can restart the unit to protect the compressor from damage.
4. The humidify and its related position number on the humidity control switch:
5.
The operational temperature range for this unit is 5-35 C°.
6.
If the dehumidifier does not start (the operational light does not illuminate) or the dehumidifier makes intermediate stop on
unknown reasons, please check the plug and power supply for poor connection. If the plug and power supply are in normal
condition, wait for 10 minutes and restart the unit (because take about 10 minutes to reposition). If the unit still does not
start in 10 minutes, please contact your local distributor service station for repair.
7.
When the dehumidifier is in operation, the running compressor will produce heat and make the room temperature higher.
This is normal condition.
DRAINAGE INSTRUCTION
The extracted water can be collected by water tank, or drained continuously
with a PVC hose (not available):
USE OF WATER TANK
When the water drain mouth is blocked by the plug, the water will automatically run to the water tank.
When the water full indicator illuminates, the tank is full, and the compressor and the fan will stop operation, please empty the
water tank:
1.
Remove the water tank as Fig 01. and empty it.
2.
Insert gently the water tank into the unit reach to its original position.
CONTINOUS DRAINAGE
1.
When you want to use this function, please pull out the water tank, and plug the discharge water pipe in “Water out
hole” (See Fig.02). replace the water tank into the unit, then you can operate the unit.
Fig
0
2
FILTER REMOVAL
•The filter can be removed from its slot by gripping the filter handle and sliding it out from the back of the appliance.
• Every 2 weeks, remove the filter and clean it with warm water, below 40°C. Allow it to dry naturally and then replace.
Fig
0
1
