UV Sterilizer Instructions
Cleaning and Changing Part:
1.
Unplug the power and pour out the water.
2.
Pull out the motor from the filter body.
3.
Clean the impeller and change UV bulb if necessary.
4.
Take out the quartz tube and clean the surface.
5.
Check if the quartz tube and O-ring are in good condition (change if necessary).
6.
Assemble the parts back together.
Product Spec
：
Model
Flow Rate
UV Wattage
Suitable
Aquarium Size
Product Dimension
CBG-500
500L/h
(132GPH)
5W
38~115L
(10-
30GAL)
192x110.5x165mm
CBG-800
800L/h
(211GPH)
5W
75~190L
(20-
50GAL)
229x127.5x179mm
Troubleshooting
：
Problem
Cause
Solution
Dirty Water
Beneficial bacteria are not
established in the new filter.
Dose some bacteria into the
filter and tank (learn more
about the Nitrogen Cycle in
Aquarium Online).
Not the right size
Upgrade to a larger filter
Too many livestock
For reference only: 1 inch of
fish per gallon of tank water
Dirty filter pads
Clean the filter pads
Dirty quartz tube
Clean the quartz tube
Water is extremely dirty
Perform a 50% water change
The UV Light Is Not On
Filter is not plug into power Plug the filter to power outlet
UV bulb burn out
Replace 5W UV bulb
The On/Off switch in Off
position
Push the switch to the On
position
No Water Coming Out
No water in filter body
Put tank water in filter body
Filter not plugged into power Plug filter to the power outlet
Intake cover clogged
Clean intake cover
Replacement Parts:
1.
UV bulb (suggest changing after 8000 hours of usage)
2.
Filter pads and media
3.
O-ring
