Ceramic shaft, wear and rust resistance
Long service life, no copper element
Multistage outlet, suitable for a variety of pipe diameter connection
Electric drive, safe and stable
External aluminum alloy radiator of the controller can dispatch well heat well
With anti-blocking and anti-idling function (cuts off power immediately and automatically if im-
peller is blocked, immediately and automatically cuts off power if pump is idling)
With alarm function, warns you of various abnormal problems
Installation
1. Notify your dealer immediately if there are external damages.
2. Compare the voltage and frequency of your electrical circuit with the data on the model plate,
these data must correspond.
3. Connect the pipeline if needed. (Attention: The piping system must not contain bubbles.) Hose
connection diagram is as follows:
This product disposes of a variety of outlets, you can select one according to the size. Loosen the nut
in clockwise direction, connect the hose, tighten the nut in anti-clockwise direction.
4.
Attention:
the pump must be installed below the water level 20 cm at least, the water surface
must be stale and horizontal.
5. Do not place the pump directly in muddy pond floors, place it on a raised surface.
6. Connect the pump with the controller of four core wire (Pic 1), lock the nut as shown in Pic 2.
© by WilTec Wildanger Technik GmbH
Item 50982, 51192
Page 4
http://www.WilTec.de
http://www.aoyue.eu
03 2021
-1
