PART NO. 690963 REV: A-01
30
Security Mode
The keypad can be locked to prevent tampering with the lift. The transmitter still functions in
Security Mode. The factory setting of the security code is 1223, but this may be changed.
The keypad has only numbers 1, 2 and 3 which are selected by pressing
‘
Power
’, ‘
Up
’
or
‘
Down
’
respectively.
To Enable Security Mode:
-Press the
‘
Program
’
button twice (to
‘
Security
’).
Enter security code (factory setting 1223
or your custom code) and press
‘
Program
’.
-Turn Security Mode
‘
Off
’
by entering the security code and pressing the
‘
Program
’
button.
To Customize your Security Code:
-Press
‘
Progam
’
twice (to
‘
Security
’),
then press and hold
‘
Program
’
for about five (5) sec-
onds until the Program light flashes in a 2-flash pattern.
-Enter the old security code and press
‘
Program
’.
Light will flash in a 3-flash pattern.
-Enter the new security code and press
‘
Program
’.
Light will flash in a 4-flash pattern.
-Enter the new security code again and press
‘
Program
’.
New code is programmed. Rec-
ord your new security code in a secure place. Your dealer can reset your code back to
factory settings if needed.
Troubleshooting the RC401
Issue:
Solution:
No 'Power' light and lift does
not operate with keypad or
transmitter
-Check battery connection
-Press Power Button on control box
-Check fuse in hydraulic pump wire harness
-Check battery voltage
Voltage should be 12VDC or higher
No lift operation with transmitter,
but works with keypad on control
box
-If 'Battery Fault' on controller, charge battery
-Enroll transmitter using 'Add Transmitter' instructions
-Verify Power light is on (see No 'Power' light solutions above)
-Replace battery in transmitter
Lift does not operate with key-
pad but does with transmitter
- If 'Security' light is on, keypad is locked with Security Mode. See
Security Mode instructions
Battery drains in Solar mode
-Verify lift is not being overused for the number of solar panels
connected
-Verify sun has direct contact with solar panel for maximum number
of hours
-Clean solar panel
Transmitter has limited range
-Reposition antenna away from electric motor or any metal inside box
-Try touching transmitter to your chin while operating (yes, it works!)
-Add LA-RCA1 extension antenna
