INSTALLATION AND ASSEMBLY
- Locating Grill
In
FIG. B,
Excess heat leaves through back of grill, but is
blocked by Prevailing Wind, causing overheating of grill.
2. Allow for Ventilation
Your Sunstone™ grill is engineered with special
vents on the back of unit, which allow proper
airflow out of the back of grill, also increased
airflow into Infra-red Burner gas chamber. Be
sure you allow a minimum of 4" behind grill for
proper air ventilation. Slide grill all the way into
cut-out, so there are no gaps present to inside
of island frame.
1. Slide Grill in Place
Your Sunstone™ grill is specially designed with
an internal built in hanger lip located at the
Right, Left and Back sides. The grill lip allows it
to hang by the three supported edges on the
right, left and back. The front control panel
requires no supporting edge; it is designed to
hang down the front of your cut-out.
3. Securing in Place
The control panel is designed to sit flush against the
island face. If counter top extends beyond the
islands face, creating a countertop overhang, it must
be cut flush with the island face where the width of
the control panel or a gap will be created exposing
the forward portions of the left and right side
firewalls.
Also be sure to allow at least a 1" of
clearance below grills drip pan, for proper airflow
ventilation.
Page
5
