Questions? Call or Text +1-801-658-0015 •
29
The Micro Welder Experts
PROBLEM
RESOLUTION
The shielding gas doesn’t flow when the pedal is
pushed.
A. Check the home screen to verify the gas flow is
turned on.
B. Check that the input pressure is not higher than 2
Bars.
C. Check the flux regulator inside the weld chamber.
D. Verify that in gas tubing is not kinked or blocked.
I try to blow compressed air from the nozzle, but no air
comes out.
A. Verify that in gas tubing in not kinked or blocked.
B. The compressed air pressure is too low.
The laser doesn’t turn on.
A. Verify that the switch placed on the back is in ON
position.
B. Verify that the emergency stop switch is released.
C. Check the fuses.
D. Verify the welder is plugged in to an active power
source.
Note: When replacing fuses, ensure that the replacement fuse is of the same rating and same type. It is always
recommended to have a fuse installed when using this welder.
